Quad mount M45- M55 Maxson Control handle right

Quad mount M45- M55 Maxson Control handle right.
Can also be used on left side, by unscrew the switch, and put it on the other side.
New old stock.  read more

Code: 6

Quad mount Elevation stop lever boot.

New old stock. This lever boot was, to prevens water and dirt would go inside motor and gearbox compartment.
Weight circa (grams): 22  read more

Code: 35

Quad mount wire assy cable Solonoid.

This cable was located on the left and richt 50 caliber support arm,s on the Trunnion,s.
there was also a connector connected on.  read more

Code: 34

Quad mount Lower vertical adjustment handwheel.

New old stock  read more

Code: 33

Quad mount upper vertical adjustment handwheel.

New old stock.  read more

Code: 32

Quad mount, Maxson Bearing Trunnion.

New old stock. Bearing, dated 1958 on the box.
Two of these bearings, one on each side of the Trunnion axle.  read more

Code: 31

Quad mount Maxson Field for electric 12 volts motor.

New old stock.  read more

Code: 30

SOE - OSS US Nr 10 Time pencil tin.

Nice US tin to store 5 time Pencil,s.
US made, and used bij OSS and SOE, items weren dropped all over ocupied coutrtry,s in Europe.

Good condition, still some remains of the red tape on the tin.  read more

Code: 29

Quad Mount Gas filter yoke assy.

New old stock.
Used to keep the gas filter in place.  read more

Code: 28

Quad mount Handle Jack

New old stock.

This is the handle what,s always missing when you buy your Maxson project.  read more

Code: 27